OBID i-
scan
®
Installation
ID ISC.LRU3000
FEIG ELECTRONIC GmbH
Page 50 of 52
LRU3000 - Manual.doc
E N G L I S H
11.2 USA (FCC)
FCC ID: PJMLRU3000
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTICE:
Changes or modifications made to this equipment not expressly approved by
FEIG ELECTRONIC GmbH may void the FCC authorization to operate this equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
-
Consult the dealer or an experienced radio/TV technician for help.
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (EIRP) is not more than that permitted for
successful communication.
This device has been designed to operate with the antennas listed below, and having a maximum
gain of 10.5 dBic. Antennas not included in this list or having a gain greater than 10.5 dBic are
strictly prohibited for use with this device. The required antenna impedance is 50 ohms. Lists of
Antennas:
ID.ISC.ANT.U250/250-FCC, ID.ISC.ANT.U170/170-FCC, ID ISC.ANT.U270/270-FCC,
ID ISC.ANT.U600/270-FCC
11.3 Canada compliance statement (IC: 6633A-LRU3000)
Operation is subject to the following two conditions:
(3) this device may not cause interference, and
(4) this device must accept any interference, including interference that may cause undesired op-
eration of the device.
Usually this is followed by the following RSS caution:
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
