Feig Electronic OBID i-scan ID ISC.LRMU1000, Руководство по установке

Страница: 47 / 52

OBID i-scan
®
Installation ID ISC.LRU1000
FEIG ELECTRONIC GmbH Page 47 of 52 M41200-2de-ID-B.doc
E N G L I S H
4 Startup
4.1 Interface configuration
4.1.1 RS485/RS422
Jumpers J7 – J8 are used to configure the asynchronous interface as an RS485 or R422 port.
Jumper RS485 RS422
J7 closed open
J8 closed open
Table 4-1: Configuration of the RS485/RS422 port
Any termination resistors needed can be enabled using jumpers J1 through J6.
Jumper Closed Open
J1 Pull-Up on RS4xx - B without Pull-Up on RS4xx - B
J2 Pull-Down on RS4xx - A without Pull-Down on RS4xx – A
J5 Termination resistor
RS4xx - A
⇔
RS4xx - B
without Termination resistor
RS485 - A
⇔
RS485 - B
J3 Pull-Up on RS422 - Z without Pull-Up on RS422 - Z
J4 Pull-Down on RS422 - Y without Pull-Down on RS422 –
Y
J6 Termination resistor
RS422 - Y
⇔
RS422 - Z
without Termination resistor
RS422 - Y
⇔
RS422 - Z
Table 4-2: Termination resistors for RS485/RS422