Feig Electronic ID MAX.U500i Series, Руководство по установке

Страница: 24 / 36

IDENTIFICATION
ID MAX.U500i 6 Operating and Display Elements
Page 24 of 36
6 Operating and Display Elements
Operating and Display Elements
6.1 Status LEDs
The status LEDs are located under the push button T1 and the DIP switches S1.
Reader status LEDs
Res.
(yellow)
Warning
(red)
COM
(yellow)
RUN
(green)
Description
FLASH - - - While T1 is pushed and hold for 5 s to initiate a reset.
ON - - - Reader performs a reset (after pushing T1 for 5 s).
- - - FLASH Reader operates normally.
- - FLASH FLASH Reader receives a valid protocol from host.
- ON - FLASH RF Warning [0x84]
- FLASH
(alternating)
- FLASH
(alternating)
Hardware warning; perform Reader Diagnostic [0x6E]
for further information.
- FLASH FLASH FLASH Firmware transfer from host to reader.
Do not switch off the reader or disconnect the interface
cable during firmware transfer!
(sequentially)
Table 10: Reader status LED overview
Antenna status LEDs
LED Label Color Description
Ext. Ant.
green UHF power switched on
blue transponder detected
red
antenna impedance error (unequal 50 Ω )
Int. Ant.
green UHF power switched on
blue transponder detected
red
antenna impedance error (unequal 50 Ω )
Table 11: Antenna status LED overview
6.2 Push Button T1
By means of the push button T1 a complete configur ati on reset can be performed. T he push button is l ocated between the DIP switches and connector X1 on the circui t board. Figure X shows the positi on of the push button. T o press the r eset button T 1 it is necessar y to open the housi ng by means of the hinge after looseni ng the screws X and X.
By means of the push button T1 the reader can be switched to Teach-In mode or a complete configuration
reset can be performed. The push button is located between the DIP switches and connector X1 on the
circuit board. Fig. X shows the position of the push button. To press the button T1 it is necessary to open the
housing by means of the hinge after loosening the screws.
6.2.1 Teach-In Mode
The Teach-In Mode can be used for easy programming of new authorized transponders if the configuration
software myAXXESS Manager is not or cannot be used. In Teach-In Mode it is not possible to configure time
restrictions for the different users. This means transponders registered via Teach-In Mode are valid and have
access 24/7.
Activation of the Teach-In Mode:
• Activate the Teach-In Mode by briefly pressing the push button T1 twice within a short time