IDENTIFICATION Installation
ID
ISC.M02.M8
FEIG ELECTRONIC GmbH
Page 15 of 16
M02M8-IM-e_02.doc
5.2 1.2. USA (FCC) and Canada (IC)
Product name:
ID ISC.M02.M8
FCC ID:
IC:
PJMM02M8
6633A-M02M8
Notice for USA
and Canada
This device complies with Part 15 of the FCC Rules and with
RSS-210 of Industry Canada.
Operation is subject to the following two conditions.
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Unauthorized modifications may void the authority granted under Federal
communications Commission Rules permitting the operation of this device.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at
his own expense.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux condi-
tions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Warning: Changes or modification made to this equipment not expressly approved by
FEIG ELECTRONIC GmbH may void the FCC authorization to operate this equipment.
Installation with FCC / IC Approval:
The reader module was tested according to the standard FCC - Title 47 CFR Part 15 §207, $209
and §225 and the ISED standard RSS 210 Issue 10 and RSS Gen Issue 5 . The module is con-
form to the listed limits in the standards.
In normal operation the RF exposure is far below the limits of OET Bulletin 65.
This module is approved for installation into fixed and/or mobile host platforms and must not be co-
located or operating in conjunction with any other antenna or transmitter except in accordance with
FCC/ISED multi-transmitter guidelines. End users must be provided with transmitter operating
conditions for satisfying RF Exposure compliance.
The manufacturer is obliged to include a notice "Contains FCC ID: PJMM02M8 an IC: 6633A-
M02M8" at the user manual and on the product label.
