6
、
ASSEMBLY
Disconnect the power plug before carrying out any adjustments or maintenance.
6.1 Inserting bit or drill
Open the chuck (1).
Insert the drill or bit in the chuck.
Tighten the chuck firmly.
Check if the bit or drill is in the centre of the chuck.
6.2 Auxiliary handle
The auxiliary handle (7) will provide additional control and support for the drill.
Slide the holder of the side grip over the drill chuck on the machine.
Turn the side grip in the required position and tighten it firmly.
6.3 Depth gauge
The depth gauge is used to limited the maximum drilling depth.
Loosen the Auxiliary handle (7).
Insert the Depth gauge (2) in the hole in the holder of the side grip.
Adjust the Depth gauge(2) to the required drilling depth.
Tighten the side grip firmly.
7
、
OPERATION
7.1 Selecting the operation mode
Select the required operating mode before use (drilling or hammer drilling).
For drilling in concrete or hard stone, push the Impact/Drill switch (8) to the impact position.
7.2 Forward / reverse lever
To select forward position (right rotation), push the forward / reverse lever to the right (R).
To select the reverse position (left rotation), push the forward / reverse lever to the left (L).
7.3 Variable speed
This tool has a speed control dial (5) that delivers higher speed by turning to the “+” position and
delivers lower speed by turning to the “-“ position.
7.4 Switching ON and OFF
Connect the tool to the power supply.
To start the machine, you squeeze the ON / OFF switch (3).
To stop the machine, you release the ON / OFF switch.
7.5 Continuous mode
To switch the machine to continuous mode, keep the on/off switch pressed and at the same time
press the lock-on button (4). Subsequently release the on/off switch.
To switch off continuous mode, press the on/off switch again.
Never put down the machine when using the continuous mode!
For drilling in wood, metal, plastics and soft stone, push the Impact/Drill switch (8) to the drill
position.
06
