Inserting Drilling Tools without SDS-plus
Note:
Do not use tools without SDS-plus for hammer drilling or chiseling! Tools without SDS-plus
and their drill chucks are damaged by hammer drilling or chiseling.
Insert a key-type drill chuck.
Open the key-type drill chuck by turning until the tool can be inserted the tool.
Insert the chuck key into the corresponding holes of the key type drill chuck ad clamp the tool
uniformly.
Turn the mode selector switch to the “Drilling” position.
Removing Drilling Tools without SDS-plus
Firmly hold the retaining ring of the quick change chuck. Open the tool holder by turning the front
sleeve until the tool can be removed.
Turn the sleeve of the key type drill chuck 2 with the drill chuck key in anticlockwise direction until
the drilling tool can be removed.
5. OPERATION
Starting Operation
Observe correct mains voltage! The voltage of the power source must agree with the
voltage specified on the type plate of the power too.
Setting the Operating Mode
The operating mode of the power tool is selected with the mode selector switch.
Note:
Change the operating mode only when the machine is switched off! Otherwise, the machine
can be damaged.
To change the operating mode, push the release button and turn the mode selector switch to the
requested position until it can be heard to latch.
Position for
hammer drilling
in concrete or stone
Position for
drilling
without impact in wood, metal, ceramic and plastic as well as
for screwdriving and thread cutting
Vario-Lock
position for adjustment of the chiseling position
The mode selector switch does not latch in this position.
08
