Inserting screwdriver bits
Apply the power tools to the screw/nut only when it is switched off .Rotating tool inserts can slip off.
To work with screwdriver bits, a universal bit holder with SDS-plus shank (accessory) is required.
Clean the shank end of the adapter shank and apply a light coat of grease.
Insert the universal bit holder with a turning motion into the tool holder until it automatically locks.
Check the locking effect by pulling the universal bit holder.
Insert a screwdriver bit into the universal bit holder. Use only screwdriver bits that match the screw
head.
To remove the universal bit holder, pull the locking sleeve 6 toward the rear and remove the
universal bit holder 15 out of the tool holder.
6. MAINTENANCE AND CLEANING
Before any work on the power tool itself, pull the mains plug.
For safe and proper working, always keep the power tolls and the ventilation slots clean.
A damaged dust protection cap should be changed immediately. We recommend having this
carried out by after-sales service.
If the supply cord is damaged, it must be replaced by a special cord or assembly available from the
manufacturer or its service agent.
Others maintenance and inspection shall be provided by a service agent.
10
