Start the generator as the above instruction.
Connect the charging cable to the generator DC socket and connect it to the battery terminal
WARNING
Connect the charging cable to the battery first, and then connect it to the generator.
Disassembly must start from the generator side, which prevents sparks start beside the
battery.
When connecting the charging cable to the car battery, disconnect the battery ground wire
first. Remove the cable and then connect to the ground wire on battery after charging is
complete. So that even if you make the battery terminal contact with the car frame by
accident, it can prevent short circuit or spark.
WARNING
Do not start the car when the generator is connected to the battery, otherwise it might
damage the generator.
Charging cable should be properly connected to the positive and negative terminals of the
battery, otherwise it will damage the generator or the battery.
WARNING
Charge should be properly ventilated, and away from fireworks, because the battery will
evaporate flammable gas.
The battery contains sulfuric acid (electrolyte). Contact with skin or eyes can cause burns.
Wear protective clothing and mask.
Electrolyte is toxic, if the electrolyte splashed on the skin, immediately rinse with water.
If the electrolyte splashes into the eyes, rinse immediately with water for 15 minutes and seek
medical care.
If you accidentally swallow the electrolyte, drink plenty of water or milk immediately, and then
drink milk or vegetable oil with magnesium oxide and seek medical care.
Batteries and electrolytes should be placed where children are not accessible.
DC protector
When using AC power, you can use DC output at the same time .
The DC circuit overload may cause DC protection. And the switch should be reset.
18