Feider Machines FDL125, Руководство пользователя

Страница: 12 / 25

cord has been damaged, have it replaced before using the saw again.
c) ALWAYS use your saw correctly according to the instruction amnual.
d) ! WARNING: If the blades come in contact with the workpiece before they reach full cutting
speed recommended, it could cause the saw to kickback towards you, resulting in serious injury.
e) ALWAYS support the workpiece near the cut and the cut ALWAYS will be on your side.
f) ALWAYS clamp the workpiece so it will not move during the cut. Before starting a cut, draw a
guideline along the desired line of cut. Then place the front edge of the saw blades on that part of
the workpiece that is solidly supported.
g) NEVER place the saw on the part of the workpiece that will fall off when the cut is made.
h) ALWAYS keep the cord away from the cutting area. ALWAYS place the cord so it does not
hang up on the workpiece when making a cut.
I) Press the on/off switch to start the saw. ALWAYS let the blades reach full speed set according
to the recommended cutting speed in the manual (Page 11), before you begin to cut into the
workpiece.
j) When making a cut, ALWAYS use steady, even pressure. Forcing the saw causes rough cuts
and could shorten the life of the saw or cause kickback.
k) ALWAYS use the lubricating device (included) when cutting Aluminum, Copper, Stainless Steel
& Cast Iron materials, because they have a tendency to smear and adhere to the blades.
l) ALWAYS wear the protective equipment (gloves, footwear, hearing/eye/respiratory protections,
etc.) when cutting metal part.
m) ALWAYS Feeding must be parallel to the blade. Feeding at an angle can burn the blade and
damage the blade teeth.
n)
Don’t Remove the Dust Extraction And ALWAYS put the Dust Cap on while cutting, if you do
not connect a dust collection pipe with the Dust Extraction; Otherwise it will cause injury.
o) Keep children and bystanders away 5 meter away while operating the tool. Especially, keep
away from the front side and back side of the cutting line area.
FEED SPEED
a) Feed speed is how quickly you push the saw blades through the material being cut.
b) The correct feed speed is totally determined by the hardness and the thickness of the material
12