ORIGIINAL INSTRUCTIONS
10
be at least six feet (1.8 meters) long.
-Extension cord wire size requirements are as follows:
-6 to 10 feet(1.8 to 3 meters),use 18 AWG wire.
-11 to 100 feet(3.4 to 30.4 meters),use 16 AWG wire.
-101 to 200 feet (30.8 to 61 meters ), use 14 AWG wire. 4.Turn thermostat control knob to desired
temperature setting
The setting range is from 40°F to 110 °F. Push the power switch to the “ON” position(See
figure 9). The power indicator lamp and room temperature display will light and the heater will start.
NOTE: The room temperature display will indicate the following:
-When room temperature is less than 0°F,display will show “LO”
If the heater does not fire, the thermostat maybe set too low. Turn the control knob to a higher
setting until heater fires, if the heater still does not start, push power switch to “OFF”, then back to
“ON”. If heater still does not fire, see Troubleshooting Guide on page15
NOTE
: The electrical components of this heater are protected by a fuse mounted in the PC board, if
the heater fails to fire, check the fuse first, and replace if necessary. Also check the power source to
be sure that the proper voltage is being provided to the heater.
Figure 6.
Control panel
TO STOP THE HEATER
Simply turn the power switch to “OFF” position and unplug the power cord.
TO RESTART THE HEATER
1) Wait 10 seconds after shutting off the heater.
2) Turn the power switch to “ON” position.
3) Be sure to follow all starting procedure precautions.
ELECTRICAL OUTLET
Shock Hazard !
-Never plug in an appliance with more than a 5 amp rating into this outlet.
-Always keep outlet covered when not in use.
Room
temperature
display
