8
3. BEFORE USE
a. Filling oil tank
NOTE: The tool must be always switched off and unplugged before fill the oil tank.
Remove the oil cap.
Pour the oil in the tank. Do not fill completely the tank to avoid spillage.
Close firmly the tank with its cap. Be sure that the cap is installed correctly.
Check the oil level once a day or before use, confirming that the oil level is no less
than the minimum requirement of 3mm in the site glass.
b. Assembly of bit
- Rotate the stop lever 180 degree in a clockwise direction while pulling it toward you.
- Insert the tool shank into the hexagonal hole on the front cover.
- Clamp the tool by turning the stop lever half a turn in the opposite direction
When removing the tools. Follow the above procedure in reverse order.
4.OPERATION
Be careful of hidden electrical lines or gas and water pipes. Check the working area, e.g. with
a metal detector.
Check the product, power cord and plug as well as accessories for damage before each use.
Do not use the product if it is damaged or shows wear.
Check that the oil level is correct before use
Double check that accessories or application tools are properly fixed.
Always hold the product by its handles. Keep handles surfaces clean and dry to ensure
safe support.
Ensure that the air vents are always unobstructed and clear. Clean them if necessary
with a soft brush. Blocked air vents may lead to overheating and damage the product.
Switch the product off immediately if you are disturbed while working with it and when
other people enter the working area. Always let the product come to a complete stop
before putting it down.
Do not overwork yourself. Take regular breaks to ensure concentrated work and full
control over the product.
Pull the trigger switch after applying the tip of the tool bit on to the object to be worked on. In
some cases, it is necessary to punch the tip of the bit against the object being worked on in
order to begin the striking stroke. This is not due to malfunction of the power tool. It means
that the safe guard mechanism against no-load striking is working.
Operate this demolition hammer by utilizing its own weight.
The performance will not be better even if it is pressed or thrust forcibly against the work
surface. Hold this demolition hammer with a force just sufficient to counteract the reaction
force
