Mounting Wings
Slide wing spar through fuse.
Extend landing gear. Slide wing on tube, connect
air lines and servo wires and slip the two aluminum
anti-rotation pins into their holes.
Secure wing with 3mm bolt into the aluminum tab
through the pre-drilled hole.
Optional: it is recommended that you add an
additional wing hold down bolt toward the front of
the wing to remove play. The bolts pictured here
are 1” 1/4-20 socket head. To install, first fit a piece
of scrap ply at least 3/16” thick on the inside of the
fuselage, against the wing root, just ahead of the
gear wheel well. Drill for the 1/4-20 bolt and secure
on the wing side with a blind nut. Use a little
Aeropoxy around the blind nut to secure it to the
former (see photo).
Cockpit Tubs and Glare Shield
Spray the tubs and glare shield flat black, or gray to
your preference.
Fit glare shield in place and secure in a few places
with a silicone or rubber based glue.
Drop the tubs in place as shown.
With the engine hatch cover in place, fit the canopy.
You may glue the tubs to the bottom of the canopy,
or just drop them in place and remove separately
when access to the component board is necessary.
FEI BAO T45
22
