Using the large washer and cap head bolt, secure the
forward rudder spar. See photo.
Connect rudder servo to the harness and tape all
three connections. Secure wires such that they are
clear of the stab servos and will not drop into the
vicinity of the pipe when it is installed.
Locate aft ventral fin and trial fit the cap head bolt into
the pre-cut slot in the bottom of the fuse. Carefully
enlarge the slot if necessary to insure a tight slip fit.
Attach the ventral fin to the lower hatch with two cap
head screws and washers. If they don’t snug
securely, put a few drops of thin CA into the holes in
the ventral fins, allow to dry, and then reinsert the
bolts.
FEI BAO T45
11
