mr
.
steam
®
Installation, Operation & Maintenance Instructions
_____________________________________________________________________________________________
7
OPTIONAL DIGITAL PROGRAMMABLE TIMER
1. Read the operating instructions provided with the timer.
2. Disconnect power supply prior to installation to prevent electrical shock.
3. Damage to the contacts caused by short circuiting will void the warranty.
4. Wire in accordance with National Electrical and Local Code requirements.
Be sure all connections are secure. Double check all twist-on wire connec-
tors.
5. Mount timer into a single gang wall box using supplied screws.
6. If timer does not operate, check that the timer's black wire is connected to
hot line and not the load. If necessary, reverse connections to red and black
wires
7.When the indicator light on the towel warmer is illuminated, the towel
warmer is energized.
AVAILABLE DECORATIVE
FACE PLATES FOR TIMER:
Polished Stainless Steel 103872D-SP
GENERAL:
The Towel Warmer requires 120 VAC, 50/60 Hz power. Specific amperage needed is listed in
the Towel Warmer Specifications Chart on page 3 of this manual.
A. Electrical connections should be made as prescribed by the National Electrical Code and
local code. The unit should be field wired using 14 AWG min 90°C-rated insulated copper
wire. All models are to be protected by a separate 15 amp circuit breaker, GFCI or equal.
B. Make connections between Towel Warmer and house wiring using approved connections to
comply with the National Electrical Code and local codes. LINE (black), NEUTRAL (white),
and GROUND.
TO PREVENT ELECTRIC SHOCK HAZARD, NO BARE WIRE OR WIRE
STRANDS SHALL BE EXPOSED AFTER MAKING CONNECTIONS.
Towel Warmer surface may continue to be hot for a period of time after it has
been turned off.
Electric Towel Warmer
Element
Heating Element
Wiring Box
Field Wiring
L
N
GRND
L
N
GRND
Field Installed Wall Switch or
Mr. Steam Digital Programmable Timer
PN: 103588DIG
Indicator Light
X
X
X
WARNING
!
WARNING
!
CAUTION
!
