mr
.
steam
®
Installation, Operation & Maintenance Instructions
_____________________________________________________________________________________________
ELECTRICAL CONNECTIONS
TO PREVENT SHOCK HAZARD,
THE ELECTRICITY MUST BE TURNED OFF AT
THE MAIN PANEL BEFORE ANY WIRING
IS ATTEMPTED.
The towel warmer is an electric
device. It must be installed by a licensed electrician in
accordance with the National Electrical Code (NEC)
and local code.
Installation of a wall switch or timer
to turn the towel warmer on and off is required.
NOTE: When the towel warmer is energized (ON), the
indicator light on the towel warmer will illuminate.
Note: The Towel Warmer wires are color coded:
BLACK for LINE, WHITE for NEUTRAL,
GREEN/YELLOW for EQUIPMENT GROUND.
Install Towel Warmers in upright
position only. Locate with wiring box and pilot light
on bottom as shown on pages 4 & 5. Failure to install
properly may result in overheating and a hazardous
condition.’
All wiring must conform to National Electrical Code
(NEC) and local code.
DO NOT alter or modify any Mr. Steam products.
Doing so may result in an inoperable or hazardous
installation and will void the warranty.
6
Wiring Box
Wiring Box
Wiring Box
Field
Wires
Wiring Box
Escutcheon
Wiring Box
Escutcheon
BX Connector
Lock Nut
BX Cable*
(or greenfield)
Wires from
wiring box
1. Assemble the BX cable
connector to the wiring box
escutcheon as shown.
NOTE:
NM (non-metallic) cable,
if permitted by National and
Local Codes, may be used
instead of BX cable
2. Secure wiring box escutcheon
to the wall with screws provid-
ed. (Use longer screws as
required by construction
conditions.)
3. Connect wiring per
instructions.
4. Slide the wiring box into the
wiring box escutcheon and
tighten the set screw firmly.
Secure the upper and lower
brackets per the instructions
on page 5.
INSTALLATION OF A 300 SERIES TOWEL WARMER WITH A JUNCTION BOX.
A wall plate is required to complete this installation. Available wall plates:Polished Chrome 104093PC
Field
Wires
Wires from
Wiring Box
Wiring Box
Wiring
Box Set
Screw
Wiring
Box
Wiring Box
Escutcheon
Wall
Plate
Screws
1. Assemble the bushing
to the wall plate and
wiring box escutcheon
as shown.
2. Secure the assembly
to the junction box
using the screws pro-
vided with the wall
plate.
3. Connect wires
per instructions
4. Slide the wiring box into the
wiring box escutcheon and
tighten the set screw firmly.
Secure the upper threaded
flanges and lower brackets with
screws provided.
WARNING
!
WARNING
!
WARNING
!
CAUTION
!
