Federal SNR48, Инструкция по установке и эксплуатации

Страница: 9 / 44

Series ’9 0 Refrigerated Bakery Page 9
DANGER:
Electric shock hazard. Do not operate unit with
panels removed.
Grill Removal
The front of the case has a removable base panel to access the anti-fogging fans and the
front leg levelers from inside of the case. Normally it is not necessary to remove the panel to
install the case. This panel must be in place for proper operation of the case.
There are two (2) removable panels on the back of the case. The left side panel allows
access to the light ballasts, the pullout condensing unit, and the field wiring connection box.
Remove this panel to make field wiring connections.
The right side panels has the thermometer, power switch, light switch, and thermostat
mounted to it. Removing this panel allows access to the terminal board, branch circuit fuse,
condensate evaporator, and compressor service ports. Normally it is not necessary to
remove this panel to install the case.
Condensate Evaporator
This case is furnished with an electric condensate evaporator. Plumbing connections are
not required.
The condensate evaporator is located behind the control panel box and is accessible from
the rear of the case.
Lights
Make certain that the light cord plugs are completely inserted into the sockets or arcing
may result causing damage to the plugs and sockets.
The ballasts used on this case allow removal of one or more shelf lights without affecting the
remaining lights.
Shelving
Remove both rear doors from the track by lifting them upward until the bottom edge clears
the lower door track and then outward.
Lift up the front glass to the fully open position.
Put the shelf support assembly in the desired shelf standard slots.
Plug the shelf light cords in the appropriate light socket. Make certain that the light cords
are completely inserted into the sockets or arcing may result causing damage to the plugs
and sockets.