Federal SN4CD, Инструкция по установке и эксплуатации

Страница: 7 / 26

Series ’90 Cold Deli Display
Page 7
Shelving
Remove both rear doors from the track by lifting them upward until the bottom edge clears the
lower door track and then outward. Lift up the front glass to the fully open position. Put the shelf
support assembly in the desired shelf standard slots.
Plug the shelf light cords in the appropriate light socket. Make certain that the light cords are
completely inserted into the sockets or arcing may result causing damage to the plugs and sockets.
Put the metal shelf on the rear shelf support assembly as shown. If the shelf is not in the proper
position, it may disrupt the air flow in the case and cause product loss.
Close the front glass and reinstall both rear doors.
Display Component Check
The display case power switch is located on the control panel at the back of the case. After the case
is properly wired to the power source, the switch should be moved to the “on” position to check the
case components. The switch should be turned off any time the case is not in operation.
The case is equipped with a top light and shelf light. The light switch is on the control panel at the
back of the case. The switch should be moved to the “on” position to verify that the lights are
working properly. The lights should be turned off any time the case is not in operation.
The refrigeration system temperature control is on the control panel at the back of the case. The
temperature control knob should be moved to a numbered position to verify that the refrigeration
system functions properly. The temperature control knob should be in the “off” position when the
case is not in use.