Federal ITH, Инструкция по установке и эксплуатации

Страница: 13 / 32

E3788-1 Rev A - ITH 13
1.
2.
3.
SHELF
STANDARD
SHELF
STANDARD
SHELF
BRACKET
SHELF BRACKET HOOK
HOOK
SHELF
STANDARD
SLOT
FLAT SHELF POSITION
5
v
SHELF POSITION
SHELF BRACKET TAB
0 AND 5
v
4. Once all shelf brackets are installed in desired position run each shelf light cord into ½ hole in
back of shelf bracket and out the ½” hole in the front of shelf bracket. The shelf light cord
length can be adjusted by pulling out cord from cord grommet or pushing cord back into cord
grommet.
5. Install front shelf supports with LED lights on to shelf brackets. All shelf supports with the
lights are the same. The LED light must be facing towards back of case. Hook shelf support
end flanges into front notch of shelf brackets on each side of case.
6. Install rear shelf supports with no lights on to shelf brackets. All shelf supports with no lights
are the same. The flange on shelf support should be facing towards back of case. Hook shelf
support end flanges into rear notch of shelf brackets on each side of case
7. Push shelf light cords into end of LED light. NOTE: Do not plug cord in backwards. There are
(2) humps on end of cord that must align with humps in end of LED light. Plugging in the cord
upside down will Damage LED light strip.
8. Manage desired cord lengths by pulling out cord from cord grommet or pushing cord back into
cord grommet.
NOTE: Cords always remain in case they are not removable.