- 17 -
SHELVING INSTALLATION & REMOVAL
Shelf Brackets and Supports
SHELF LIGHT,
SET INTO FRONT NOTCH
ON SHELF BRACKET
SHELF LIGHT CORD CLIP & SCREW,
SCREW TO SHELF BRACKET
ON SIDE OF SHELF LIGHT CORD
REAR SHELF SUPPORT,
SET INTO REAR NOTCH
ON SHELF BRACKETS
2 POSITION SHELF BRACKET,
HOOK INTO SHELF STANDARD
CLEAR BUMPER, ATTACH
TO FRONT OUTSIDE CORNER
OF ALL BRACKETS
1.
Turn the light switch to the off position. Remove rear doors as described in the “Rear Door Removal”
section of this manual to allow access to interior of case.
2.
For first time installation it may be necessary to attach the clear plastic clips to only the shelf brackets
located on the side of the shelf light cord. Use the 6-32 x ¼ flat head screws supplied with unit to
attach clear plastic clips to the 1/8 hole on the inside of the shelf brackets. It may also be necessary to
attach the clear bumper to the outside end towards the side glass of each shelf bracket. The bumper
prevents damage to the end glass. These steps may have already been performed at the factory for you.
Insert a longer bottom shelf bracket in the desired shelf standard slot on one side of case (bumper side
towards end glass). Follow the instruction in the illustration below. Place the additional longer bottom
shelf bracket in the same shelf standard slot on the opposite end of case. Repeat for shorter top shelf
tier.
0
v
NOTCH
6
v
NOTCH
4
1
2
3
4
INSTALLATION
REMOVAL
2
3
1
TOP HOOK
BOTTOM TAB
SHELF BRACKET
SHELF STANDARD
1. Place shelf bracket top hook into desired shelf
standard slot.
2. Lift shelf bracket top hook to allow shelf bracket
bottom tab to clear shelf standard slot.
3. Swing shelf bracketbottom tab into shelf standard
slot.
4. Place the desired shelf bracket notch of 0, 6, or 12
degrees onto bottom of shelf standard slot.
1. Lift shelf bracket up to allow shelf bracket notch
to clear the bottom of shelf standard slot.
2. Swing shelf bracket bottom tab out of shelf
standard slot.
3. Drop shelf bracket down to allow shelf bracket top
hook to clear top of shelf standard slot.
4. remove shelf bracket top from shelf standard slot.
CLEAR BUMPER
TOWARDS END PANEL
