Configuring the Lightbar
35
SmartSiren Platinum Series
Lightbar Default Settings
Before you begin, you may want to review these lightbar default settings. For an keypad view of the
default settings, see the table in the appendix on page 115.
Button
Button Control
Pattern
Auxiliary Function
Slide Switch 1
Momentary*
Lightbar Pattern 10
Front Light Cutoff
Slide Switch 2
Momentary*
Lightbar Pattern 17
Slide Switch 3
Momentary*
Lightbar Pattern 26
Flash Takedown/Alley
Button 1
Push On/Off
Left Alley
Button 2
Push On/Off
Takedowns
Button 3
Push On/Off
Right Alley
Button 4
Timer
Intersection Pattern 22
Button 14
Push On/Off
Dimming
Button 15
Push On/Off
Rear Light Cutoff
* The Button Control Module is not available because the option cannot be changed.
NO
TE
Verify features before configuring the lightbar
Federal Signal lightbars may not have all the features available in the lightbar pane.
To make the software configuration of the control pad quick and accurate, determine
what hardware features and DIP switch settings are in the lightbar before you begin.
Assigning Lightbar Functions to Buttons
Buttons 1
to
5
and
Buttons 14
and
15
can be programmed to activate when the operator puts the
slide switch into a position linked to one or more of these buttons. If you are configuring this feature,
first determine which buttons and functions to activate and their corresponding slide switch positions.
See “Linking Buttons to Slide Switch Positions (Lightbar Pane)” on page 39.
To assign lightbar functions:
1.
Click any button except
SignalMaster
and
Warn
:
NO
TE
Button Function Limits
The functions for all buttons (except
Slide Switch 3
, which accepts a limit of 20)
are limited to a maximum of 10.
Содержание SmartSiren Platinum Series
Страница 1: ...Control Pad Configuration Software Manual 2562418C REV C 411 Printed in U S A...
Страница 6: ...6...