4
Installation and Maintenance Instructions
Models QL64-BTT, QL64-TURN, QL64-ARROW, and QL64-BACKUP
Installing the QuadraFlare
INSTALL IN RECOMMENDED AREAS
:
When installing equipment
inside airbag equipped vehicles, the installer MUST ensure that
the equipment is installed ONLY in areas recommended by the
vehicle manufacturer.
Failure to observe this warning reduces the effectiveness of the
airbag, damage the airbag, or potentially damage or dislodge the
equipment, causing serious injury or death to you or others.
NOTE
: For maximum coverage and effectiveness, mount the light
assembly in a horizontal orientation (see Figure 1).
Before proceeding with installation, determine the approximate
location of the light assembly and plan all cable/wire routing.
To install the QuadraFlare models, proceed as follows:
1. See Figure 1. Position the QuadraFlare warning light assembly
on the desired mounting surface. Ensure that the unit is level
side to side. Using the dimensions provided in Figure 2, scribe
the four mounting hole locations and a wiring routing hole
location on the mounting surface.
DRILLING PRECAUTIONS
:
Before drilling holes in ANY part of a
vehicle, be sure that both sides of the mounting surface are clear
of parts that could be damaged; such as brake lines, fuel lines,
electrical wiring or other vital parts.
2. Drill four 1/4" (0.250") mounting holes and a wire routing
hole 1" (1.00") at the previously scribed locations.
3. Install the four supplied rubber rivet nuts into the four 1/4"
mounting holes.
DRILLING PRECAUTIONS
:
All drilled holes should be free of
burrs and sharp edges. Grommet (user supplied) all wire routing
holes and/or sealed to avoid wire and/or vehicle damage.
