6
Installing the QuadraFlare
QuadraFlare
®
DOT
Federal Signal
www.fedsig.com
Installing the QuadraFlare
INSTALL IN RECOMMENDED AREAS: When installing equipment
inside airbag equipped vehicles, the installer MUST ensure that the
equipment is installed ONLY in areas recommended by the vehicle
manufacturer.
Failure to observe this warning reduces the effectiveness of the
airbag, damage the airbag, or potentially damage or dislodge the
equipment, causing serious injury or death to you or others.
NOTE
: For maximum coverage and effectiveness, mount the light
assembly in a horizontal orientation. See Figure 1.
Before proceeding with installation, determine the approximate
location of the light assembly and plan all cable/wire routing.
AIRBAG DEPLOYMENT: Do not install equipment or route wiring in
the deployment path of an airbag. Failure to observe this warning
will reduce the effectiveness of the airbag or potentially dislodge
the equipment, causing serious injury or death.
To install the QuadraFlare:
1.
Position the QuadraFlare Warning Light assembly on the
desired mounting surface. Ensure that the unit is level side to
side. Using the dimensions provided in Figure 1, scribe the four
mounting hole locations and a wiring routing hole location on
the mounting surface.
