MB-IDENT03 Identifier Board Installation, Maintenance, and Service Manual
2
MB-IDENT03 Identifier Board
Federal Signal
www.fedsig.com
• Do not attempt to wash any unsealed electrical device while it is connected to its power source.
During Installation and Service
• DO NOT get metal shavings inside the product. Metal shavings in the product can cause the system
to fail. If drilling must be done near the unit, place an ESD-approved cover over the unit. Inspect the
unit after mounting to verify that there are no shavings present in or near the unit.
• DO NOT connect this system to the vehicle battery until ALL other electrical connections are made,
mounting of all components is complete, and you have verified that no shorts exist. If the wiring is
shorted to the vehicle body or frame, high current conductors can cause hazardous sparks, resulting
in electrical fires or flying molten metal.
• DO NOT install equipment or route wiring (or the plug-in cord) in the deployment path of an airbag.
• Before mounting any components, check the manual to ensure that the component you are installing
is suitable for use in that area of the vehicle. Many components are not suitable for use in the engine
compartment or other extreme environmental exposure areas.
• When drilling into a vehicle structure, ensure that both sides of the surface are clear of anything that
could be damaged. Remove all burrs from drilled holes. To prevent electrical shorts, grommet all
drilled holes through which wiring passes. Ensure that the mounting screws do not cause electrical or
mechanical damage to the vehicle.
• Refer to the manual packed with the lighting system for proper electrical connections, additional
precautions, and information.
After Installation or Service
• After installation, test the light system to ensure that it is operating properly.
• Test all vehicle functions, including horn operation, vehicle safety functions, and vehicle light systems,
to ensure proper operation. Ensure that the installation has not affected the vehicle operation or
changed any vehicle safety function or circuit.
• If a vehicle seat is temporarily removed, verify with the vehicle manufacturer if the seat needs to be
recalibrated for proper airbag deployment.
• Scratched or dull reflectors, mirrors, or lenses will reduce the effectiveness of the lighting system.
Avoid heavy pressure and the use of caustic or petroleum-based products when cleaning the lighting
system. Replace any optical components that may have been scratched or crazed during system
installation.
• Do not attempt to activate or deactivate the light system control while driving in a hazardous situation.
• Frequently inspect the light system to ensure that it is operating properly and is securely attached to
the vehicle.
• After installation and testing are complete, provide a copy of these instructions to instructional staff
and all operating personnel.
• File these instructions in a safe place and refer to them when maintaining and/or reinstalling the
product.
Failure to follow all safety precautions and instructions may result in property damage, serious injury, or
death.
