6
Installation and Maintenance Instructions
LED Traffic Clearing Light Model LEDTCL64
Installing the Lights
NOTE:
The light heads are to be installed in a horizontal
orientation, rotated 180 degrees from each other. (See Figure 1
on page 9).
To install the lights:
1.
Determine the approximate locations of the light heads and
plan all wire routing.
2.
Position a light head on the mounting surface. Ensure that
the light head is level-side to-side. Using the dimensions in
Figure 2 on page 10, scribe the locations of the four mounting
holes and a wire routing hole.
3.
Complete Step 1 for the other light head.
4.
For each light head, drill four 1/4 in (0.25 in) mounting holes
and a 1.00 in wire routing hole at the scribed locations.
5.
Install the eight supplied rubber rivet nuts into the 1/4 in
mounting holes.
6.
Complete the electrical connections in “Wiring the Lights.”
7.
See Figure 1 on page 9.
With the arrow on the inner lens
pointed toward the outer edge of the vehicle, align the light
heads with the rivet nuts.
8.
Secure the light heads with the #6-32 S.S. screws.
Wiring the Lights
Refer to Table 3 and the instructions below.
Each light head has three 12 in long lead wires exiting the rear
of the housing. Ensure that all wires are properly terminated
and insulated.
Table 3
Wire Functions
Red
+12/24 Vdc
Black
– Ground
Green
Pattern Select/Sync
