12
Installation
Informer15 Speaker (Model I-IP15)
Flat Surface Mounting
The speaker can be mounted on any relatively flat surface. Conduit connections can be
made to the two 1/2-inch threaded openings at bottom of the housing. A 1/2-inch conduit
plug is supplied for field installation if one of the 1/2-inch threaded openings is not used.
After the mounting location and mounting method have been selected, proceed with the
applicable instructions below.
To flat surface mount the Informer15 Speaker:
1. Select the mounting location and place rear of the housing against mounting surface.
2. Use the four mounting holes on the external housing bracket as a template, scribe
drill position marks on the mounting surface. See Figure 1 for mounting hole
locations and dimensions.
Before drilling holes in any surface, ensure that both sides of surface are clear
of items that could be damaged.
3. Secure the unit to a wooden mounting surface with #10 x 1-inch wood screws. If
mounting on a metal surface, drill 13/64-inch diameter holes and secure the unit with
#10 screws, lock washers and nuts.
4. Route wires through the 1/2-inch threaded openings into the Informer15 Speaker unit
in accordance with National and Local Electrical codes.
5. Reposition speaker projector if necessary to obtain desired sound coverage. Loosen
collar nut and move projector to desired position. (See Figure 1.)
Figure 1 Depth and Height of Informer15 Speaker
1.50" [38 mm]
5.50" [140 mm]
6.00" [152 mm]
CONDUIT
ENTRANCE
1/2"-14" NPT
(2 PLCS.)
1.00" [25 mm]
2.30" [58 mm]
Ø0.20" [Ø5 mm]
MOUNTING HOLES
(4 PLCS.)
10.0" [253 mm]
3.38" [86 mm]
1.12" [28 mm]
2.00" [51 mm]
13.9" [353 mm]
10.2" [258 mm]
8.6" [219 mm]
