9
Installation and Maintenance Instructions
Model eHorn
Mounting the eHorn with the Brackets
For dimensions, see Figures 2 and 3 on page 10.
NOTE:
For trunnion (U‑bracket) mounting, the Model
EHORN‑TKIT is available as an accessory. Refer to instruction
manual 25500314 for bracket kit details.
To secure the eHorn to the mounting surface:
1.
See Figure 1. Attach the mounting brackets to the eHorn
with the six supplied 1/4 in‑20 x 5/8 in screws. Tighten
them to 80 +/‑10 in‑lb.
Figure 1 Brackets attached to eHorn
1/4"-20 x 5/8" (6)
290A7910
2.
Hold the eHorn against the mounting surface and use the
two mounting holes on the bracket as a template. Scribe
drill‑position marks on the mounting surface.
3.
Remove the eHorn and drill a hole at each mark.
4.
Secure the eHorn to the mounting surface using installer‑
supplied 1/4 in screws.
