1
INSTALLATION AND SERVICE INSTRUCTIONS FOR SHOCK
MOUNT KIT FOR COMMANDER
®
MODEL 371 LIGHTS
SAFETY MESSAGE TO INSTALLERS,
USERS AND MAINTENANCE PERSONNEL
It is important to follow all instructions shipped with this product. This device is to be installed
by a trained electrician who is thoroughly familiar with the National Electric Code/Canadian
Electric Code and will follow the NEC/CEC Guidelines as well as local codes.
The selection of mounting location for the device, its controls and the routing of the wiring is
to be accomplished under the direction of the facilities engineer and the safety engineer. In
addition, listed below are some other important safety instructions and precautions you should
follow:
•
Read and understand all instructions before installing or operating this equipment.
•
Do not connect this light to the system when power is on.
•
After installation, ensure that all threaded joints and bolts are properly tightened.
•
After installation, test the light system to ensure that it is operating properly.
•
After testing is complete, provide a copy of this instruction sheet to all operating personnel.
•
Establish a procedure to routinely check the light installation for integrity and proper
operation.
Failure to follow all safety precautions and instructions may result in property damage, serious
injury, or death to you or others.
I. INSTALLATION
This product is intended to be used in conjunction with either the Model 371, 371L,
371DST, or 371ST products. These instructions are intended to supplement, and not replace
the installation instructions provided with each of these models. The installer should insure
that all installation instructions are followed.
A. Unpacking
After unpacking the equipment, examine it for damage that may have occurred in transit.
If the equipment has been damaged, do not attempt to install or operate it. File a claim
immediately with the carrier stating the extent of the damage. Carefully check all
envelopes, shipping labels and tags before removing or destroying them.
B. Mounting
The Model 371 series of lights can be mounted on a flat horizontal surface using the
shock mount kit as follows (refer to figure 1).
a. Using the gasket provided with light as a template or dimensions shown in figure 2,
scribe drill position marks for the three mounting holes and center wiring hole on the
mounting surface. Drill 9/32” (7.1 mm) diameter holes at the drill position marks
for the mounting holes and a 3/8” (9.5 mm) diameter hole for the supply wiring.
