34
Operating the Mobile Camera System
Mobile Camera System
Federal Signal
www.fedsig.com
buttons and pressing the Menu button. The selected option
is red; all other options are yellow. Adjust the scale with the +
(increase) and
–
(decrease) buttons. The scale disappears after
approximately four seconds of inactivity. Select Return if you
are finished setting the menu options; the menu disappears.
The MIR/NOR button enables you to switch the displayed
camera image to either a mirror image or a normal image.
This setting is retained in memory so that even when the
system is turned off, the preferred setting (mirror or normal) is
recalled when you turn on the system.
NOTE:
The MIR/NOR button is available only on the
CAMSET56-AHD-NTSC2 system.
Option 2: System Configured with a CAMLCD-AHD-70
monitor (as in CAMSET70-AHD-NTSC4)
When you turn on the camera system by turning the vehicle
ignition key to either the “Accessory” or “On” position, the
monitor operates in one of two ways, depending on the
Power Button setting in the monitor menu.
If Power Button is set to Action when you turn on the camera
system by turning the vehicle ignition key to either the
“Accessory” or “On” position, the red power indicator LED on
the monitor turns on (Figure 11). To manually turn the system
on, briefly press the /CAM SEL (power/camera select)
button. The split-screen image of all connected cameras,
or the last display configuration selected, which is stored in
memory, will appear on the monitor. See below for screen
configuration specifics.
If Power Button is set to Off when you turn on the camera
system by turning the vehicle ignition key to either the
“Accessory” or “On” position, the red power indicator LED
on the monitor illuminates and the monitor configures the
display based on the number of cameras connected to the
system as follows.