Federal Signal Corporation 371DST, Руководство по установке и обслуживанию

Страница: 6 / 24

4
3. Carefully remove the flash tube from its socket by grasping the connector and lifting
upwards using a slight rocking motion.
4. See replacement parts table (Section IIB) for a complete list of Federal Signal lamps that
are available. Install a new flash tube by fully seating it into the socket.
5. Reassemble the unit.
6. Test light for proper operation.
B. Replacement Parts.
Description Part No.
Plastic Dome Assembly, Amber K8459125
Plastic Dome Assembly, Blue K8459125-01
Plastic Dome Assembly, Clear K8459125-02
Plastic Dome Assembly, Gree K8459125-03
Plastic Dome Assembly, Red K8459125-04
Fresnel lens, Clear K8422B428
Dome ring gasket K8459123
Surface mount gasket K8459127
Strobe Tube K8107178
Printed circuit board assy., 12-24VDC K2001265-01
Printed circuit board assy., 120VAC K200865-02
Printed circuit board assy., 240VAC K200865-03
C. Accessories.
Description Part No.
Mounting Bracket, Surface 371BRCKT
Conduit hub kit, 3/4” N.P.T. 8459138
Close-up plug, 1” N.P.T. 8459130A
III. SERVICE
The Federal factory will service your equipment or provide technical assistance with any
problems that cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair must be accompanied by a
Return Material Authorization. This R.M.A. can be obtained from a local Distributor or
Manufacturer’s Representative.
At this time a brief explanation of the service requested, or the nature of the malfunction, should
be provided.
Address all communications and shipments to:
Industrial Systems
2645 Federal Signal Drive • University Park, IL 60484-3167
Tel.: 1-708-534-4756 • 1-877-289-3246 • Fax: 1-708-534-4852
www.federalsignal-indust.com • www.fs-isys.com