Rev. 1.00
- 15 -
FEC-150
Refer to the following settings of the DIP switch.
3-1 Setting the DIP Switches
3-1-1 Setting the DIP switch (RS-232C Serial Interface)
• DIP Switch
SW
Function
ON
OFF
Default
1-1 Auto
Cutter
Disable Enable
OFF
1-2 Reserved -
1-3
OFF
1-4
Baud Rate
Refer to Table 1
OFF
• Table 1 – Baud rate (bps) Selection
Transmission Speed
1-3
1-4
Default
9600 OFF
OFF
19200 OFF
ON
38400 ON
OFF
115200 ON
ON
9600
3-1-2 Setting the DIP switch (IEEE1284 Parallel, USB2.0 Interface)
• DIP Switch
SW
Function
ON
OFF
Default
1-1 Auto
Cutter
Disable Enable
OFF
1-2
-
1-3
-
1-4
Reserved
-
3-2 Setting the Memory Switches
This printer has “Memory Switch” set which is software switches. Memory Switch set has
“MSW1”, “MSW2”, “MSW8”, “MSW9” “Customize value”, “Serial communication condition”.
“Memory Switch setting utility” can change the Memory Switch set to ON or OFF as shown
in the table below. (default : all OFF)
※
NOTE
- The Memory Switch is available to be changed by three methods.
- Memory Switch setting utility.
- Control from BXL/POS command.
Settings of the Memory Switch are stored in the NV memory : therefore, even if the printer
is turned off, the settings are maintained.
