febromed get up, Инструкция по эксплуатации

Страница: 13 / 24

get up® Instruction Manual F-049 GB Rev00 02.05.2019
13
If surface disinfectant finds its way to unpro-
tected eyes, serious damage can occur.

Always wear protective glasses with side
protection when in contact with surface
disinfectant.

If brought into contact with eyes:
Immediately rinse the eyes carefully for
several minutes using tap water of drinking
quality.
Remove your contact lenses beforehand if
possible.

Follow the safety instructions of the
disinfectant manufacturer.
WARNING
Danger of Slipping Due to Wet Floors
Floors soaked in surface disinfectant are
slippery and can cause people to fall.

Immediately remove spilt surface
disinfectant with an absorbent material such
as a cloth or fleece.
WARNING
Property Damage Due to Unsuitable Surface
Disinfectants
Unsuitable surface disinfectants can perma-
nently damage the surface of the get up®.

Use the surface disinfectants approved by
the manufacturer.

A list of suitable and approved
disinfectants can be found in chapter
17.3
– page 17.

Only use surface disinfectants of an
alcoholic strength by volume of
less than 25 g ethanol (94 %) per 100 g
disinfectant.

Only use surface disinfectants of an
alcoholic strength by volume of
less than 35 g propan-1-ol per 100 g
disinfectant.

Only use surface disinfectants:

- without iodine.

- without ammonia .

- without hydrochoric, phosphoric and
acetic acid.

Only use surface disinfectants which
neither scratch nor scrub.
DANGER
Danger of Fire and Explosion
If surface disinfectants are brought into contact
with ignition sources such as open flames, fire
and explosions can occur.

Comply with the fire and explosion safety
regulations when employing alcoholic
surface disinfectants.

Always use surface disinfectants out of the
reach of ignition sources.

In case of fire:
Only control the burning area with
extinguishing powder, foam, water spray or
carbon dioxide (CO2) as suitable
extinguishing agents.

Observe the instructions of the disinfectant
manufacturer.
1. Disinfect the get up®
after each
use.
2. Dilute the surface disinfectant with lukewarm
water according to the manufacturer
specifications.
3. Dampen the fleece with the mixture of
surface disinfectant and tap water of drinking
quality.
4. Moisten the get up® with the fleece.
5. Allow the surface disinfectant to take effect
according to the manufacturer specifications.
6. Wipe the get up® with a fleece soaked in tap
water of drinking quality.

The get up® is now disinfected.