PAGE 5 OF 17
INSERT OPERATING INSTRUCTIONS
5.
Flame
: Press to activate the flame function. This
button controls the brightness of flame and ember
effect. When the fireplace is first turned on, the
flame will come in at the highest setting; press
DOWN or UP button to adjust the brightness of
flame. There are 6 levels you can cycle through,
including the OFF setting (the ember remains on.)
When adjusting the flame brightness with UP and
DOWN button, the number of the flam level bars
corresponds to the 5 brightness levels. When this
feature is on, display screen FLAME icon is on
also.
Figure 5
Figure 6
5
6
6. Heater:
Press to activate the heater function.
The system will start the temperature setting at
95F. There are 7adjustable heat levels, ranging
from 65F to 95F. Press the DOWM or UP button to
adjust the levels, noting each level increases or
decreases the temperature by 5F. When this
feature is on, display screen HEATHER icon also.
And when this feature is off, the inner blower will
continue to run for additional 1 minutes to cool
down the unit order to protect the heating elements
before the unit completely shuts off.
Note: You can switch the temperature display
from Fahrenheit to Celsius by pressing and
holding the HEATER button control panel for
approximately 6 seconds, the display screen
will show the room temperature.
