• To clean strainer or replace seat/stem module, shut off supply, loosen
Locknut and Lock Seal and back off Adjusting Screw.
• Remove Spring Cage, Spring, Washer and Slip Ring. Grasp Stem Nut
with fingers or pliers and lift module from body.
• Replace module and reassemble valve.
• Readjust pressure setting.
Adjustment
Regulator is factory preset to 50psi (345 kPa). To adjust pressure setting,
loosen the lock nut and turn the adjusting bolt clockwise to increase pres-
sure, counter clockwise to decrease pressure.
Note:
Use a pressure gauge downstream to adjust and verify the pressure
setting.
Bypass Feature*
This regulator has a built-in thermal expansion bypass feature. This feature
prevents downstream pressure from rising to more than 10psi above the
supply pressure.
* Bypass will not work if inlet pressure is above 150psi (10.3 bar).
Troubleshooting
High System Pressure
If the downstream system pressure is higher than the set pressure under
no flow conditions, the cause could be thermal expansion, pressure creep
or dirt/debris on the seat.
Thermal expansion occurs whenever water is heated in a closed system.
The system is closed when supply pressure exceeds 150psi, or a check
valve or backflow preventer is installed in the supply piping.
You must make provisions for pressure relief protection of your plumbing
system and components. The use of a relief valve or potable water expan-
sion tank may be required.
To determine if this is the result of thermal expansion, try briefly opening
the cold water tap. If the increased pressure is caused by thermal expan-
sion, the pressure will immediately be relieved and the system will return
to the set pressure.
Stem Nut
Strainer
Stem Nut
Strainer
SEAT/STEM MODULE
SEAT/STEM MODULE
Adjusting
Screw
Lock Nut
Lock Seal
Spring Washer
Spring
Spring Cage
Stem Nut
Slip Ring
Seat/Stem
Module
Strainer
Maintenance Instructions
Repair Kits
1
⁄
2
" – 2" (15 – 50mm)
When ordering, specify Ordering Code, Kit number and Valve Size.
Ordering Code
Kit No.
Size
in.
mm
0710606
PRV-1, PRV-2 EZ-RK
1
⁄
2
",
3
⁄
4
", 1"
15, 20, 25
0710607
PRV-1, PRV-2 EZ-L-RK 1
1
⁄
4
", 1
1
⁄
2
", 2" 32, 40, 50
Kit consists of:
Seat / Stem module.
Adjusting
Screw
Lock Nut
Lock Seal
Spring Washer
Spring
Spring Cage
Slip Ring
Seat/Stem
Module
PRV-2-U
1
⁄
2
" - 1" (15 - 25mm)
PRV-2-DU
1
1
⁄
4
" - 2" (32 - 50mm)
A Division of Watts Water Technologies, Inc.
USA: 4381 N. Brawley • Ste. 102 • Fresno, CA • 93722 • Tel. (559) 441-5300 • Fax: (559) 441-5301 • www.FEBCOonline.com
Canada: 5435 North Service Rd. • Burlington, ONT. • L7L 5H7 • Tel. (905) 332-4090 • Fax: (905) 332-7068 • www.FEBCOonline.ca
IS-F-PRV-2 0845
EDP# 1915945
© FEBCO, 2008
Limited Warranty:
FEBCO warrants each product to be free from defects in material and workmanship under normal usage for a period of one year from the date of original shipment. In the event
of such defects within the warranty period, the Company will, at its option, replace or recondition the product without charge.
THE WARRANTY SET FORTH HEREIN IS GIVEN EXPRESSLY AND IS THE ONLY WARRANTY GIVEN BY THE COMPANY WITH RESPECT TO THE PRODUCT. THE COMPANY MAKES NO OTHER
WARRANTIES, EXPRESS OR IMPLIED. THE COMPANY HEREBY SPECIFICALLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for breach of warranty, and the Company shall not be responsible for any incidental, special
or consequential damages, including without limitation, lost profits or the cost of repairing or replacing other property which is damaged if this product does not work properly, other costs resulting
from labor charges, delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any other circumstances over which the Company has no
control. This warranty shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or alteration of the product.
Some States do not allow limitations on how long an implied warranty lasts, and some States do not allow the exclusion or limitation of incidental or consequential damages. Therefore the above
limitations may not apply to you. This Limited Warranty gives you specific legal rights, and you may have other rights that vary from State to State. You should consult applicable state laws to
determine your rights.
SO FAR AS IS CONSISTENT WITH APPLICABLE STATE LAW, ANY IMPLIED WARRANTIES THAT MAY NOT BE DISCLAIMED, INCLUDING THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL SHIPMENT.
