FCC BBQ PERFORMANCE II 4.1s, Руководство пользователя, Страница: 25 / 32

MANUAL LIGHTING
If the electric ignitor of the appliance does not work or you like to light the appliance manually using
match holder, a long match or a fireplace lighter:
1.
Set all control knobs to off.
2.
Open the lid.
3.
Open the gas valve of the gas cylinder.
4.
Light a long match or long lighter and enter it into the burner
ports on the right sidewall of the firebox.
5.
Push the control knob of the adjacent burner in, and turn it to
the left to HI position.
6.
Make sure the burner lights and stays lit.
7.
Adjacent tube burners can be lighted by pushing their knobs in and turning them to the left.
If the burners do not ignite after 5 seconds, set all control knobs to off (red bar pointing upwards) and
close the gas valve of the gas cylinder.
Wait for 5 minutes. Repeat the above procedure.
L I G H T I N G I N S T R U C T I O N S
IF THE BURNER DOES NOT IGNITE, TURN THE SWITCHES TO THE OFF POSITION
(CLOSE THE GAS SUPPLY) AND WAIT 5 MINUTES BEFORE TRYING TO IGNITE AGAIN.
IF THE BARBECUE STILL DOES NOT LIGHT WITH NORMAL OR MANUAL METHOD,
READ THE TROUBLESHOOTING TABLE OR CONTACT YOUR DEALER.
!
DO NOT LEAN OVER THE BARBECUE WHILE LIGHTING!
LIGHTING INSTRUCTIONS
1.
Set all control knobs to off.
2.
Open the lid. The lid must always be open when lighting the grill.
3.
Open the gas valve of the gas cylinder.
4.
Push and hold the ignitor button , at the same time push and turn any control knob slowly to
HI position. Press the ignitor button until the grill is lit. If the burner do not to light within 5
seconds,shut down the gas supply and wait 5 minutes, then repeat the procedure.
5.
Wait until the burner is lit, then the next burned may be lit with the same procedure.
6.
Ignite the rest of the burners the same way as needed.
TIPS: Preheat the BBQ for about 10-15 minutes on maximum temperature. After completion of
preheating, turn all burners to the LO position for best cooking results.
If the burners do not ignite after 5 seconds, set all control knobs to off position and close the gas valve
of the gas cylinder. Wait for 5 minutes. Repeat the above procedure.
25