- 17 -
Using a Pager
If programmed, the system can send messages to a pager. The messages display
as follows:
ACCT E XXX
where:
"ACCT"
= the 4-digit central station no. 2 account number.
"E"
= is the event code. There are 4 event types: alarms, troubles,
openings, and closings. These event codes are as follows:
Openings = 0, Closings = 1, Alarm or Trouble = 9
"XXX"
= the zone (01-48) or user (1-64) designation, depending on the event
If multiple events occur, the signal for the highest-priority event is sent first. Events
ranked from highest to lowest priority are alarms, trouble, open, and close.
CHANGING THE PAGER PHONE NUMBER (FOLLOW-ME)
You can change your pager follow-me phone number as follows if your installer
enabled this feature:
1.
Access pager number programming by pressing in sequence the [#], [5],
and [8] keys. An acknowledgement tone sounds to indicate pager number
programming has been accessed.
The #
[5], [8] command is accessible only while the system is disarmed and the
dialer, dialer delay, and bell are not active.
In pager phone number programming mode, only the alpha keypad provides visual
display the of the numbers already programmed or numbers that are being
changed. The LED and fixed-glass style keypads provide no visual keypad display
of these numbers.
2.
Enter your new pager phone number. Your new pager phone number may
consist of up to 16 characters (1-9, 0). It may be necessary to add time to
allow the pager to answer before dialing your pager number. To enter a 2-
second pause, press the [Code] key. (Entering a 2-second pause is optional
and is not required to enter your pager phone number.) If the [Code] key
was pressed, it counts as one character. The keypad will emit a single
acknowledgement chirp as each number is pressed.
