FBII Omni-408A, Руководство по установке и настройке, Страница: 73 / 96

Section 11 - Data Entry Via LED Based Keypads
11–3
Movement Within Questions
The zone LEDs display the question number and the other status LEDs display the contents
(data) within each location. Movement from location 1 to the next location within any
question can be performed by pressing the [#] key.
The other status LEDs display the contents of each location as this key is pressed.
Data Entry
To alter the value in any location, enter the desired digit from the program sheet, then press
the [#] key to advance to the next location, or if no further changes need to be made, press
[Stay] to exit programming.
NOTE: If an entry error was made and the [#] key was not yet pressed, re-enter the desired
entry, then press the [#] key to advance to the next program location or press [Stay] to exit
programming.
Pressing the respective key on the keypad can perform numeric entries 0-9. Entries of A-F
require 2 keystrokes, as follows:
Press the [Code] key followed by 1-6 keys for values A-F.
VALUE KEYSTROKES VALUE KEYSTROKES
A
[Code] [1]
D
[Code] [4]
B
[Code] [2]
E
[Code] [5]
C
[Code] [3]
F
[Code] [6]
Example: To enter an A, press the [Code] key followed by the [1] key.
Exit System Program Mode
After all programming has been completed, press the [Stay] key to exit the system Program
mode.
Question Acknowledgment
The keypad chirps on each keystroke. In addition, a beep confirms advancement between
question numbers.
Four beeps signify an invalid input entry. After you make an invalid entry, the system
positions you at the same question number and location as immediately before you made the
invalid entry.