- 8 -
Turning The System On
(cont)
Determine which zone or zones are not ready, resolve the problem, and turn the
system on normally. If the problem cannot be resolved, you may bypass the
zone that is not ready. Bypassing should only be done if the problem on the
zone cannot be resolved, OR if you intentionally wish to leave the zone off. For
example, you would leave the zone off if you plan to keep the window open for
ventilation. Zones that are bypassed are not protected when the system
is on. See Bypass on the following page for a description of the procedure.
TO TURN THE SYSTEM ON AND STAY INSIDE
To turn the perimeter portion of your burglar alarm on and move around freely
inside the premises, use the STAY mode.
Check to make sure the system is ready. When it is ready, press:
STAY
followed by your user code.
When the system has been turned on successfully, the On/Off (ARM) light and
the STAY light will be lit, or the LCD will display:
ON: STAY
REMEMBER:
You must turn the system off if you want to open the door or
leave the premises after the exit time has passed.
TO TURN THE SYSTEM ON IN INSTANT MODE AND STAY INSIDE
In INSTANT STAY mode, the perimeter portion of your burglar alarm system
is on and the time delays are eliminated from your normal entry/exit door(s).
All interior protection is off, so you are free to move around inside.
Check to make sure the system is READY. When it is ready, press:
INSTANT
followed by
STAY
followed by your user code.
When the system has been turned on successfully, the On/Off (ARM) light, the
INSTANT light, and the STAY light will all be on, or the LCD will display:
ON: STAY INSTANT
NOTE:
This system can be programmed by the installer for the AUTOSTAY
feature which automatically bypasses interior zones if you arm the system and
do not exit through a delay zone during exit time.
