FBI XL-1T, Инструкция по установке и настройке

Страница: 50 / 72

XL-1T Installation and Setup Guide
7–14
Entry of any valid User Code will silence the sounder and the bell, and will reset smoke
detector power. If the system detects that the fire zone is still violated within two minutes of
power reset, the zone LED will pulse slowly to indicate a fire trouble. Thereafter, smoke
detector power will be reset every four minutes automatically in an attempt to clear the fire
zone.
In the event the fire zone experiences an open circuit, the system indicates fire trouble by
slowly pulsing the keypad zone LED and sounder. The system Trouble Code, followed by the
Zone Code, will be reported to the CS.
The keypad sounder can be silenced through entry of any valid User Code.
Fire zones cannot be bypassed. Zone 4 can be programmed as a fire zone for bell supervision.
24-HR. ALARM - This zone type is always active, independent of the system arming status.
Programming options include audible (STEADY BELL) or silent (NO BELL or keypad
indications). Upon violation, the zone LEDs will pulse rapidly (audible zones only) and an
immediate CS transmission will occur that cannot be aborted.
24-hour alarm zones can be bypassed; however; they cannot be unbypassed if a violation
exists on the zone terminals.
24-HR. TROUBLE - This zone type is always active, independent of the system arming
status. Programming options include audible (PULSING KEYPAD SOUNDER) or silent.
Upon violation, the zone LED will slowly pulse. A trouble condition must exist for 15 seconds
before a transmission will occur. The keypad display and sounder will clear upon zone
restoral.
24-hour trouble zones can be bypassed; however; they cannot be unbypassed if a violation
exists on the zone terminals.
24-hour trouble is not to be used for fire and burglary detection zones. 24-hour silent alarm zones
are not to be used for perimeter protection. The sounder may be silenced through entry of any
valid User Code.
WARNING: Fire zones cannot be bypassed. 24-hour zones can be bypassed;
however; they cannot be unbypassed if a violation exists on their terminals.
Zone Alarm Codes
As previously specified, locations L3 and L4 of the zone questions represent the Alarm Code
that will be reported to the central station.
Zones will transmit to the central station unless these digits are defined as AA for any individual
zone, or the local dialer option is selected for all zones in question #04, location 1.
Based on the dialer format selected, enter the Alarm Code as follows:
STANDARD FORMAT (3X1 or 4X1): Enter the desired single-digit Alarm Code in location
L3 for the specific zone. The value placed in L4 will not be used.