39
If the function "
The touch sensor is
automatically connected to the main
system"
is activated, the program au-
tomatically puts the touch function on
the primary monitor, if only one monitor
is connected.
The
Operation mode
settings allow you
to set the size of the touch area on your
faytech touch-screen. E.g. if you select
the "right screen“, after a new calibra-
tion only the right side of the monitor
will work as a touch area. If you select
"other" and then click on the ->> button,
you can set more modes or set an indi-
vidually touch-defined area.
Edge Compensation tab: fine adjustment
of the touch area
On this tab you can finely adjust the
touch area. This is very useful when you
have problems touching at the edges of
the touch screen. In the following image
you can see that the limits for all edges
of the screen were corrected (to 110%).
E.g. if you have problems in the upper
right area, just increase the upper and
right limit (
>> Bigger
). Confirm the
change and try the new settings with
the
Draw Test
. You can also use the
X-axis and Y-axis displacement options
to compensate if your touch always
seems to be off the same amount in the
X and/or Y directions.
The "
Support Edge Compensation
"
option optimizes the touch detection in
the corners of your faytech touch panels.
This option should always be enabled.
Hardware and About tabs:
The last two tabs are for information
only - there are no options to select on
these tabs.
The
Hardware
tab gives information
about the design of the faytech touch
display and the firmware used.
The
About
tab gives information about
the touch driver version as well as in-
formation about the developer of the
software.
Touchkit program in the taskbar
With the Touch Kit icon in the taskbar,
you can use a right mouse click to make
quick changes in many of the Touch Kit
settings. The individual functions have
already been described in this chapter.
