Fayat Group BOMAG BF 800 C, Руководство по обслуживанию

Страница: 14 / 41

1.2
Safety regulations
BOMAG 14 008 917 73
Engine
!
Danger
Do not work on the fuel system while the engine is
running. (Danger to life!)
Once the engine has stopped wait approx. 5 min-
utes for the system to depressurize. The systems
are under high pressure. (Danger to life!)
Keep out of the danger zone during the initial test
rung. Danger caused by high pressure in case of
leaks. (Danger to life!)
When performing work on the fuel system make
sure that the engine cannot be started uninten-
tionally during repair work. (Danger to life!)
l
Maintenance and cleaning work on the engine must
only be performed with the engine stopped and
cooled down. Make sure that the electric system is
switched off and sufficiently secured against being
switched on again (e.g. pull off ignition key, attach a
warning label).
l
Observe the accident prevention regulations for
electric systems (e.g. -VDE-0100/-0101/-0104/-
0105 Electric precautions against dangerous con-
tact voltages).
l
Cover all electric components properly before wet
cleaning.
Battery
l
Always wear goggles and protective clothing to
service or clean batteries! Battery acid can cause
severe injury by cauterization when coming in con-
tact with skin.
l
Work only well ventilated rooms (formation of oxy-
hydrogen gas).
l
Do not lean over the battery while it is under load,
being charged or tested (danger of explosion).
l
Keep ignition sources away from the battery. Burn-
ing cigarettes, flames or sparks can cause explo-
sion of the battery
l
Use battery chargers etc. only in strict compliance
with the operating instructions.
l
After an accident with acid flush the skin with a suf-
ficient amount of water and seek medical advice.
l
Do not allow children access to batteries.
l
When mixing battery fluid always pour acid into wa-
ter, never vice-versa.
Special safety regulations
l
Use only genuine BOMAG spare parts for repair
and maintenance work. Genuine spare parts and
original accessories were specially developed, test-
ed and approved for the machine.
l
The installation and use of non-genuine spare parts
or non-genuine accessories may therefore have an
adverse effect on the specific characteristics of the
machine and thereby impair the active and/or pas-
sive driving safety. The manufacturer explicitly ex-
cludes any liability for damage caused by the use of
non-original parts or accessories.
l
Unauthorized changes to the machine are prohibit-
ed for safety reasons.
l
Do not perform any cleaning work while the engine
is running.
l
If tests on the articulated joint need to be performed
with the engine running, do not stand in the articu-
lation area of the machine (danger of crushing!).
l
If tests must be performed with the engine running
do not touch rotating parts of the engine (danger of
injury!).
l
Always ensure an adequate supply of fresh air
when starting in closed rooms. Exhaust gases are
highly dangerous!
l
Refuel only with the engine shut down. Ensure strict
cleanliness and do not spill any fuel.
l
Always ensure an adequate supply of fresh air
when refuelling in closed rooms.
l
Dispose of used filters in accordance with applica-
ble environmental regulations.
l
When performing repair and maintenance work col-
lect oils and fuels in suitable containers and dispose
of in compliance with applicable environmental reg-
ulations.
l
Do not heat up oils higher than 160 °C because they
may ignite.
l
Wipe off spilled or overflown oil using suitable
cleaning means and dispose of in accordance with
applicable environmental regulations.
l
Dispose of old batteries according to applicable en-
vironmental regulations.
l
There is a danger of scalding when draining off en-
gine or hydraulic oil at operating temperature! Allow
engine and hydraulic system to cool down to a suf-
ficient level.
l
Do not exceed the max. permissible tire pressure.