![FAVORIT TCA 502 Скачать руководство пользователя страница 81](http://html1.mh-extra.com/html/favorit/tca-502/tca-502_user-manual_546832081.webp)
13
Functions and Features
of the bath stove
Strength against corrosion
The inner drum of your bath stove, in-
cluding the water input and output pipes
are enamel plated following the welding
operation are fully protected against cor-
rosion. The heater resistance is protected
against corrosion with Magnesium bar.
Strength against water
pressure
Bath stove's inner drum is tested under 6
bar pressure considering the water mains
pressure.
Effective Heat Isolation
The bath stove is isolated using a 50mm
thick polyurethane heat isolation materi-
al between the main body sheet and the
water drum. Thank to this material the
water in it will be heated rapidly and cools
down slowly.
Limiting Thermostat
The limiting thermostat will disable the
resistance in case of excessive tempera-
tures in the drum or the failure of tem-
perature setting thermostat.
V Automated Switch
You can switch ON and OFF the ther-
mostat using the V-Automated switch.
V - Automated Switch acts as a safety
device. It will disconnect the product
from the mains in case of an electrical
short circuit or the product is switched
OFF.
The provided V-Automated
Switch should be installed by an author-
ized service technician only�
Safety Valve
Safety valve is installed on to the cold
water inlet of the bath stove. A kind of
safety, this valve will prevent the draining
of the water inside in case of a water cut.
Also the same valve will discharge water
from the drain tip in case of overpressure
in the boiler.
Operating
After your bath stove is installed and op-
erationalized by the authorized service,
you can turn it on by pushing the on/off
button on the front panel.
• Ensure that the bath stove is filled
with water before the initial use.
Switch on the V-Automated switch.
• During the initial operation the
temperature set will flash on the
display panel. After a short interval
the flashing will stop and the current
inner temperature will be displayed.
You can set the desired temperature
using the up and down arrows found
next to the display. After setting the
temperature resistance is activated
and the resistance indicator on the
left bottom becomes active.
• When the water temperature reach-
es the target temperature the re-
sistance will be deactivated and the
resistance indicator will flash and the
shower sign will be activated. In this
case the hot water is ready to use.
• When the temperature lowers to a
level 4 degrees below the set tem-
perature, the resistance will be acti-
vated again and the water is heated
to the target temperature.
Содержание TCA 502
