Step 6: Use the last 7mm bolt to loosely attach the final leg to the projector. You
can then rotate the leg and slide it into the leg assembly. Replace the 8mm bolt you
removed in Step 2. Do not tighten it yet.
Step 7: After adjusting the leg assembly so that the middle is lined up with the front of
the projector, tighten all the bolts. You will need the 7mm wrench to tighten all four 7mm
bolts. When finished, the leg assembly should look like this:
Step 8: Locate the swivel mechanism. It should look like this:
There are two screws in it which need to be temporarily removed with the Allen wrench.
Then you can slide this piece into the top of the leg assembly. There are two rivets that
slide into the top of the leg assembly like so:
