ENGLISH
5.
C
ONNECTING
AND
TESTING
THE
SCOREBOARD
Once the Radio Receiver has beem installed, you can
proceed with connecting the electrical power supply and the
serial data cables.
5.1
C
ONNECTING
THE
R
ADIO
R
ECEIVER
1. Make sure you have disconnected the power supply by
turning off the power switch.
2. Insert the power cord plug (Fig. 8) into the wall socket
(chapter 2).
3. Connect the electronic scoreboards to the Radio Receiver
via the serial data cables.
5.2
P
ROCEDURE
OF
A
SSOCIATING
THE
R
ADIO
R
ECEIVERS
At this point the Radio Receiver should be associated with
the designated Command Console, so that it only receives
data from this console and no other.
4. Switch on the Command Console and only the Radio
Receiver(s) which are associated with it, making sure that
no other Consoles are switched on.
5. If there are other Radio Receivers in the same location or
vicinity associated with other Consoles, it is advised to
check that they are switched off, in order for them to not
be involved in the associating procedure.
6. From the Command Console press the buttons
; select “Yes” from the parameter “Connect new
scoreboards” and wait circa 1 minute until the value “No” returns automatically.
The Radio Receiver should now be associated with the Command Console and will begin sending data to the various
connected scoreboards; after this initial set up, you do not have to repeat the procedure when switching on the Console again;
connection to the Console will occur automatically: the procedure will need to be repeated only if you wish to connect the
Receiver to another Command Console.
Note that all Radio Receivers which are switched on and functioning will be permanently associated with the
Console, provided that they are not already in communication with other Consoles.
5.3
T
ESTING
THE
R
ADIO
R
ECEIVER
Once the Radio Receiver has been installed and associated with the Command Console:
1. Through the proper hole, make sure that the red LED inside the Receiver is illuminated and flashing (Fig. 8); if it is not
illuminated, substitute the power supply (chapter 6.4). If it is illuminated but not flashing, check the radio connection
(chapter 6.1.3).
2. Make sure that the scoreboards display all the information present on the Console’s screen; otherwise, see chapters 6.1.1,
6.
M
AINTENANCE
This chapter contains information on how to quickly resolve the main problems that may occur with the Radio Receiver over
time. For problems with scoreboards, consult the relative installation manuals. If you have further problems that cannot be
solved herein, please contact us.
265-I01E Rx Radio FS Installation
Page 3/ 5
FAVERO ELECTRONIC DESIGN
Fig. 8: Connecting the scoreboards
Fig. 6: Detail of installation on wall
Fig. 7: Installation on FS-24s scoreboard
