− 5 −
EFFECT AND MIXER CONNECTION
The external effects may be connected between both preamps (CLEAN and LEAD) and the
MASTER section through the parallel EFFECT LOOP.This type of connection is recommended
when the Volume pedal or Delay, Reverb, Flanger type of effects are used.IMPORTANT: The
volume potentiometers in channels 1−2−3 determinate the amount of gain sent to the
effects. If too much signal is sent to the effect, unwilling distortion can occur. In which case
the Volume potentiometers should be gradually lowered. Subsequently, the sound level
should be equalized by increasing the volume by MASTER potentiometer. When the mixer or
the external amplifier is connected, the LINE−OUTPUT with integrated cabinet simulator
must be used. Such would simulate the sound of a 412 Celestion Vintage 30 Cabinet. The
cabinet simulator enhances the sound that is sent to the stage monitors as though it were
coming from a stage cabine
t. Signal from Line−out can be lead in different ways: with
simulation, without simulation or both see Fig.A.
Signal without speaker simulation
Stereo jack
Mono jack
Ground
Ground
Fig.A
LINE−OUT wire connection
Signal with speaker simulation
Signal with speaker simulation
Effect pedals
IN
IN
OUT
OUT
Mixer
IN
OUT
Made in Poland
Fuse: 2.5A
NUMBER:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS PRODUCTS
TO RAIN OR MOISTURE
WARNING!
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER.REFER
SERVICING TO QUALIFIED
SERVICE PERSONNEL
CAUTION!
SEND
EFF
LOOP
(PA-INPUT)
Two mode output:
NORMAL
SPEAKER SIMULATION
SELECTABLE POWER OUTPUT:
90W/40W [RMS]
POWER
RETURN
4−8−16
ohm
GAIN
EXT. CTRL.
MIX MODE
NORMAL
Ch−1
Ch−2
Ch−3
BOOST
LINE OUT
200W/rms power stage
INSIDE
Input for exter
nal contr
oller or
foot−switches
