FAURE FRA25600WA, Руководство пользователя

Страница: 9 / 16

Problem Possible cause Solution
The door has been opened too fre-
quently. Do not keep the door open longer than
necessary.
The product temperature is too high. Let the product temperature decrease
to room temperature before storage.
The room temperature is too high. Decrease the room temperature.
Water flows on the rear plate
of the refrigerator. During the automatic defrosting proc-
ess, frost defrosts on the rear plate. This is correct.
Water flows into the refrigera-
tor. The water outlet is clogged. Clean the water outlet.
Products prevent that water flows in-
to the water collector. Make sure that products do not touch
the rear plate.
Water flows on the ground. The melting water outlet does not
flow in the evaporative tray above
the compressor. Attach the melting water outlet to the
evaporative tray.
The temperature in the appli-
ance is too low. The temperature regulator is not set
correctly. Set a higher temperature.
The temperature in the appli-
ance is too high. The temperature regulator is not set
correctly. Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too high. Let the product temperature decrease
to room temperature before storage.
Many products are stored at the
same time. Store less products at the same time.
The temperature in the refrig-
erator is too high. There is no cold air circulation in the
appliance. Make sure that there is cold air circula-
tion in the appliance.
Replacing the bulb
If you want to replace the bulb, do these steps:
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as shown in
the figure.
4. Replace the bulb with one of the same power and
specifically designed for household appliances
(the maximum power is shown on the light bulb
cover).
5. Fix the lamp cover in place.
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installa-
tion".
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
9