1st edition, 20.04.2021
7000.05072, 1st edition, 20.04.2021
7000.05072
Safety
10
Soiling, foreign bodies, humidity and mechanical influences can damage the electronics.
Keep foreign objects away from the electronics.
Install the Motion Controller in a housing that protects it from mechanical influences
and is adapted to the ambient conditions (protection class determination).
Installation and connection work while supply voltage is applied at the device can damage
the electronics.
Do
not
insert or withdraw connectors while supply voltage is applied at the Motion
Controller.
During all aspects of installation and connection work on the Motion Controller, switch
off the power supply.
Incorrect connection of the pins can damage the electronic components.
Connect the wires as shown in the connection assignment.
2.2.3
Heat development
Active components may cause the Motion Controller to heat up. If touched, there is a risk of burn-
ing.
Protect the Motion Controller against being touched and cool sufficiently.
If necessary, affix a suitable warning sign in the immediate vicinity of the controller.
Fig. 1:
Suitable warning sign acc. to DIN EN ISO 7010
2.3
Environmental conditions
Select the installation location so that clean dry air is available for cooling the Motion
Controller.
Select the installation location so that the air has unobstructed access to flow around
the drive.
When installed within housings and cabinets take particular care to ensure adequate
cooling of the Motion Controller through the base plate.
Select a power supply that is within the defined tolerance range.
Protect the Motion Controller against heavy deposits of dust, in particular metal dust
and chemical pollutants.
Protect the Motion Controller against humidity and wet.
