Installation
1. Ensure that the ½” water supply lug is not protruding from the wall more than
15mm. Remove any debris or tile glue from the lug, wind sufficient thread tape
onto the lug
2. Place the flange on the shower arm (For Cascade place the dress ring behind
the already fitted flange)
3. Screw the arm onto the lug by hand (do not use wrench) until the arm is close to
the tiles
4. Press the flange up against the wall on Pegasi and Zeos models
5. Fit the shower head to the arm (no thread tape required) and fasten gently using
a shifting spanner
6. Run and test the shower
7. The lower nut on the ball joint may be tightened slightly by hand should the
swivel action be too loose
