15
At that time, can double click the line where the desired Ethernet module
is located or single click the line and click ’Properties..’ button to perform
the configuration. If password not setting or correct password were
entered will show the screen as below
Follows are the description of each field shown in above
Firmware Version
: Denotes the software version of Ethernet module for
configuration.
IP Address
: IP address of Ethernet module for configuration.
Subnet Mask
: Subnet mask of Ethernet module for configuration.
Gateway
: The IP address of gateway for Ethernet module for
configuration.
Host Name
: For documentation, can be used to distinguish Ethernet
module. At most can consist of 11 characters.
Comment
: For documentation, can be used to distinguish Ethernet
module. At most can consist of 21 characters.
Operation mode
: Client or server mode selection.
Protocol
: There are two communication protocols were supported in this
module.
Modbus/TCP
or
Fatek
.
Modbus/TCP
can be choosed only when
the operation mode is set to Server mode while the Fatek mode can be
used in both modes.
Baud Rate(CM25E/CM55E)
:
Communication speed between Ethernet
module and PLC with
9600, 19200, 38400,57600,115200,230400 bps
six
options
。
Remote Config. Enabled
: For security, when this option is checked will
allow the configuration thru the Internet. It must be checked when intent
to configure the network configuration according to the method described
in section5.3.4. It’s strongly recommended to set the password when
www.manasanat.ir
