Step 4: Securing the Slate
With the help of another person, place the middle section of (#33) slate on the center supports of the base.
Measure from the edge of slate to outer edge of end cross beams. Make sure this piece is centered
perfectly, is square to all sides, and that the overhang is equal on both sides.
Place each end section of slate in position on the base. Check to make sure all sections are flat on the
base. Double-check overhang and if necessary, adjust to make sure it is equal on all sides.
The 3 sections of slate should be set tightly against each other to give the appearance of a
solid table top. Slide a folded piece of paper into the joint between each end section and the
middle section. This prevents the edges of the slate from sticking together and chipping while
slate is being leveled.
Use the (#47) 3/8" Allen wrench to adjust each of the 16 slate levelers (already inserted in the slate by
manufacturer) until all are flush with the base.
This is very important.
20
33
20
20
20
20
20
20
20
20
20
20
20
20
31
20
20
20
33
33
31
31
31
★
PRO TIP
★
5
