Page 3
Install Flip
™
jack foot with trailer parked on level
ground both side-to-side and front-to-back.
Never exceed max 1,400 lb. tongue weight rating.
Install only on a 2” jack with a 1-3/4” outside dimension inner jack
tube.
STEP 2
Drill Hole in Jack
Step 2a - Options for Jacks with pre-existing holes in inner-jack tube
Step 2b - Locating hole in square jack
Step 2c - Locating hole in round jack
Step 2a
- Options for Jacks with pre-existing holes in inner-jack tube.
Jacks with a pre-drilled holes may interfere with the Flip installation or
operation. Please read the following three options before going on to locating
the install hole for your Flip jack foot. You may need assistance from your
dealership when performing these options.
If your jack does NOT have a pre-existing hole at the bottom of the inner jack
tube, skip to
Step 2b.
STEP 1
Locate trailer on a flat level surface
, such as a driveway or parking lot. Chock
both sides of the trailer, and set tow vehicle parking brake. Keep trailer coupled
to tow vehicle, or place jack stands under trailer tongue to support trailer without
the use of the tongue jack. Disconnect trailer plug, safety chains, and safety
breakaway cable from the tow vehicle and move them out of the way.
Installation Instructions
